
Rigatoni alla gricia
Roman “white amatriciana”: rigatoni finished in the pan with rendered guanciale and its fat, Pecorino Romano and black pepper, with no tomatoes, garlic or onion. Following traditional Roman cooking; 4 servings.
Total time: 35 min4 servingsFinal yield 1,100 g
Ingredients
- 320 gPasta, dry, unenriched
- 200 gPork, fresh, variety meats and by-products, jowl, raw
- 60 gCheese, romano
- 2 gSpices, pepper, black
- 630 mlBeverages, water, tap, drinking
- 2.4 lBeverages, water, tap, drinking not counted – removed
- 2 gSalt, table editorial addition
Allergens
Contains: Gluten, Milk
May contain: Egg
Derived from ingredients – check the package label.
Method
- Cut the rind off the guanciale and cut the meat into strips of about 0.5 × 1 × 3 cm. Finely grate the pecorino and crush the pepper coarsely.
- Put the guanciale into a cold, wide pan without any fat and render it over low to medium heat for about 10 minutes until golden with crisp edges. Lift the strips onto a plate with a slotted spoon and leave the fat in the pan.
TipRendering bacon and lardBacon needs patience: on gentle heat its fat runs out and it crisps, on fierce heat it burns outside and stays rubbery within.Show less
Why
The fat in bacon and in pork back fat is held in the cells of fatty tissue bound together by connective tissue; heat liquefies the fat so it gradually runs out, the water evaporates, and the lean parts shrink and turn crisp. This takes time, which is why bacon goes into a cold pan, even with a little water, and is heated over medium heat: the water keeps the temperature low at first, the fat renders before the surface scorches, and the bacon crisps evenly. In a fiercely hot pan the surface burns, the fat blackens and smokes, and the fatty parts stay rubbery. Pork fat for cracklings is rendered over gentle heat with frequent stirring until the cracklings are light brown and crush easily; overcooked cracklings give dark lard with a burnt taste. Bacon cured with nitrite also forms nitrosamines when fried over fierce heat, and EFSA regards dietary exposure to nitrosamines as a health concern, so this is one more reason to fry bacon until crisp, not black.
How to do it
- Cut the bacon into slices, strips or cubes of even thickness, spread it in a cold pan in a single layer and, if you like, add about 4 tablespoons of water.
- Heat over medium heat and turn it now and then; the water evaporates and the bacon then keeps frying in its own fat.
- Take the bacon out as soon as it is golden brown; it crisps further on paper towel, and if it is dark while still in the pan, it is overcooked.
- Cut pork fat for cracklings into even cubes and render it in a heavy pot over gentle heat, stirring often, until the cracklings turn golden.
- Carefully strain the hot lard through a sieve into dry jars and keep it covered in the fridge once cool; never add water to hot fat, it boils up violently and spatters.
- Use the fat rendered from bacon to soften onions or vegetables; let the rest set and put it in the bin, not down the drain.
If it goes wrong
Put rubbery bacon back in the pan and let it keep rendering slowly over gentle heat until it crisps. Burnt bacon cannot be saved, it is bitter; take fat that has blackened or smoked heavily off the heat, let it cool a little, pour it carefully into a dry container and carry on in a clean pan. If the cracklings catch on the bottom before they release their fat, lower the heat and stir more often. Lard that has darkened and smells scorched is edible, but use it only where a stronger flavour does no harm.
- Bring 3 litres of water with 20 g of salt to the boil and cook the rigatoni 2–3 minutes less than the packet says (usually 9–10 minutes). Set aside about 200 ml of the pasta water and drain the rigatoni.
TipCooking pastaPasta water isn't waste, it's liquid glue that talks the sauce into clinging to the pasta.Show less
Why
In the first minutes of boiling, starch is released from the surface of the pasta and it turns sticky; plenty of rapidly boiling water and a stir at that point stop it clumping, and the water doesn't cool down as much when the pasta goes in. Salt only gets into pasta while it cooks, which is why the water is salted generously, roughly 10 g per litre; that amount has a negligible effect on the boiling point, and oil in the water is pointless because it floats on top and doesn't prevent sticking. The cooking water is full of dissolved starch that thickens the sauce and helps its fat combine with water into a smooth emulsion that clings to the pasta. That is why pasta isn't rinsed after draining – you would wash off the starch the sauce holds on to and cool the pasta down; the only exception is pasta for a cold salad.
How to do it
- Allow roughly a litre of water per 100 g of pasta and add about 10 g of salt per litre once it boils.
- Drop the pasta into rapidly boiling water and stir now and then for the first two minutes.
- Don't add oil to the water; it won't stop sticking.
- Cook a minute or two less than the packet says and keep tasting.
- Before draining, scoop out a mugful of the cooking water.
- Don't rinse the pasta; transfer it straight into the sauce and finish cooking it there with a little of the cooking water.
If it goes wrong
Loosen pasta that has stuck together in the sauce with a little hot cooking water, or dip it briefly in boiling water and stir. Overcooked pasta won't firm up again – bake it or add it to a soup, and next time start tasting earlier. Under-salted pasta can only be rescued by a well-seasoned sauce.
- Tip the rigatoni into the pan with the fat, add 100 ml of pasta water and toss over medium heat for 2–3 minutes until al dente and the water and fat have come together into a light, glossy emulsion.
- Take the pan off the heat, let it cool for a moment and stir in 40 g of the pecorino and the pepper in portions, with a spoonful of pasta water if needed, so the sauce stays creamy and the cheese does not clump. Finally stir in the guanciale and serve at once, sprinkled with the remaining pecorino.
Recipe tradition
Not yet verified
This recipe has not been checked against a documented culinary reference.
Food data sources
- USDA FoodData Central SR Legacy (2018-04) · USDA Agricultural Research Service, FoodData Central SR Legacy. · CC0 1.0 Universal
Nutrition
Calculated from the selected ingredients; not a laboratory measurement.
Whole recipe
- Energy
- 2,734.4 kcal
- Protein
- 73.8 g
- Fat
- 160.3 g
- Total carbohydrate (by difference)
- 242.4 g
- Total dietary fibre (USDA)
- 10.7 g
- Saturated fatty acids
- 61.7 g
- Sodium
- 1,729.8 mg
- Salt (sodium × 2.5)
- 4.3 g
Per serving
- Protein18.4 g11%
- Fat40.1 g53%
- Total carbohydrate (by difference)60.6 g36%
Share of energy from protein, fat and carbohydrate (4 / 9 / 4 kcal per g), not share by weight.
- Energy
- 683.6 kcal
- Protein
- 18.4 g
- Fat
- 40.1 g
- Total carbohydrate (by difference)
- 60.6 g
- Total dietary fibre (USDA)
- 2.7 g
- Saturated fatty acids
- 15.4 g
- Sodium
- 432.4 mg
- Salt (sodium × 2.5)
- 1.1 g
Per 100 g of finished food
- Energy
- 248.6 kcal
- Protein
- 6.7 g
- Fat
- 14.6 g
- Total carbohydrate (by difference)
- 22 g
- Total dietary fibre (USDA)
- 0.98 g
- Saturated fatty acids
- 5.6 g
- Sodium
- 157.3 mg
- Salt (sodium × 2.5)
- 0.39 g
Salt is calculated from sodium (g salt = mg sodium × 2.5 / 1000) and includes sodium from all ingredients.
A dash means the value is unknown, not zero.
Calculation limitations
- Nutrition is a calculated estimate, not a laboratory measurement.
- The final yield is an editorial estimate.
- Some ingredient quantities use documented estimates or household-measure assumptions.
- The number of servings is an editorial estimate (midpoint of the source range or based on the dish type and energy).
- Some specific ingredients are represented by the closest generic food with the same culinary function.
- Fibre, saturated fat and sodium of cooked ingredients are estimated from the consumed ingredient amounts; for drained ingredients, sodium is included only where the retained amount is an explicit editorial estimate.
- Some process effects could not be resolved in this calculation.